Anyone done any Terminator lightning claws that could give me some advice?

Here's my attempt with plastic card. It's basically 4 little strips cut to length and then I trimmed each so that the bottom half is flat/straight and the top was angled/curved to give the curving blade shape.



Here's my attempt with milliput. It has the luxury of the banner behind it to use as a base for the claw. I basically laid the putty flat, cut the blades into the putty then levered the blades up at the end away from the banner for the curve.



Hope this helps anyway.

If doing them over Chaos Terminators - they have the power glove up the front, I am going to try thin wire for the claws topped with greenstuff - not sure whether it will work however.

There is plasticard, however I am not convinced in it's use for this - Dobbsy did a good job however on his which is making me rethink it's use.

Failing the above, I will start looking in the bits box for stuff to cut up and use for claws.

Hope these ideas help

Cheers...

_________________
Frogbear is responsible for...
Previous World Eaters
Previous Emperor's Children
Previous Death Guard
Previous Imperial Fists
Previous Chaos Squats

thanks for the info, I was trying to decide whether to use plastic card too. Still a bit undecided yet. This is for the normal none chaso Terminator I am using.