OK... I gave in and did some Tau base markings for people. So for those that didn't see my last thread what I did was make some triangular markers to fit on the AI bases under the Altitude label. The last lot were Orks.
Now the main sheet is the standard Tau Ochre but this can be fixed easily. All you need to do is open the sheet in your graphics program and alter the hue and saturation eg.
If you want a really dark shade like Red gore, Invert the sheet and then alter hue and saturation eg.
This is what the whole sheet looks like.
All you need to do is
1) print them out at 620 pixels / cm (1575 pixels / inch)
2) Spray the sheet with some gloss varnish, to give them a bit of protection
3) Cut them out with a pair of scissors.
4) Paint the back of them with PVA (Will be really easy to remove if you need too)
DOWNLOAD FULL RESOLUTION VERSION
