Step-1
Cut sprues for main body and outer edges in sprues are a bit thicker so they fit better.
(I made them 2,5cm long). Then make other end round shaped to resemble engine and form front as triangle. (helps to fit front plates)
Step- 2
For wings I used 0,5mm thick plasticard. Just use main body to give good size and changing forms gives difference in raiders appearance. ( I made them look similar to each formation).
Step-3
Front plates were also made out of 0,5mm thick plasticard. I made plating in two different sets, but Most of you are so skilled that maybe three would look much better. Also making them to be over another makes them look nice (just thin edges a bit or use thinner plasticard)
http://i122.photobucket.com/albums....197.jpg
Step-4
Tail was made of 1mm plasticard to give it more strength, this is also good part to make raiders differ from each other. Just make your kind of tail and sharpen the edges to give it more DE look. And wing part in tail was 0,5mm plasticard or 1mm with sharpened edges. Also there was made little triangles to resemble drivers helmet.
http://i122.photobucket.com/albums....199.jpg
Step-5
For ravagers side plates (0,5mm) I made little bits to strengthen them.
Step-6
Now it is good time to fix with green stuff all holes and such. Then add crew, for Dark Lance gunner I used ranger model and disintegrator gunner is a guardian. Spikes for their helmets was made of 0,5mm plasticard by making sharp triangles. Also manes were made out of green stuff.
For spikes in raider I used extra spikes that came in 40k warrior box. Drivers arms are thin plasticard bits.
Bases are just 25mm closed round base with 15mm screw through it.
Now just ask if you need help or something. Also sorry for language...
Also more pics are here.
)
