I purchased a Landing Craft that was missing a few parts: front door, some gear, all weapons. I had some spare 3D-printed weapons for it but decided since I have a White Scars army to make it into something a little unique and transport bikes.
The pictures below give you an idea of where it's going. It's still rough, needs mold lines trimmed, green stuff for gaps and most of the parts are not glued in place yet (not until it has been painted). The two red circled parts will likely be cut off. This will allow you to see more of what is being transported. I thought about putting some more weapons on these "arms" but I think the landing craft has enough weapons as-is.
I likely will build landing gear in an up position as the craft could use this platform as gear when on the ground. For the bikes to get out, the bottom door would open and they would jump out while the landing craft was low to the ground or the entire thing could be dropped off. I can't decide if I want to have the bottom door open and have a bike jumping coming out or just leave it closed. I would need to pick one because the stand will have to go into this door. If open, I'll need to add some support to the ramp as all of the weight will be on it.
