| Tactical Command http://www.tacticalwargames.net/taccmd/ |
|
| Terminator Lightning Claws http://www.tacticalwargames.net/taccmd/viewtopic.php?f=7&t=19076 |
Page 1 of 1 |
| Author: | Lextar [ Tue Sep 07, 2010 11:14 pm ] |
| Post subject: | Terminator Lightning Claws |
Anyone done any Terminator lightning claws that could give me some advice? |
|
| Author: | Dobbsy [ Tue Sep 07, 2010 11:28 pm ] |
| Post subject: | Re: Terminator Lightning Claws |
Here's my attempt with plastic card. It's basically 4 little strips cut to length and then I trimmed each so that the bottom half is flat/straight and the top was angled/curved to give the curving blade shape.  Here's my attempt with milliput. It has the luxury of the banner behind it to use as a base for the claw. I basically laid the putty flat, cut the blades into the putty then levered the blades up at the end away from the banner for the curve.  Hope this helps anyway. 
|
|
| Author: | frogbear [ Wed Sep 08, 2010 2:22 am ] |
| Post subject: | Re: Terminator Lightning Claws |
If doing them over Chaos Terminators - they have the power glove up the front, I am going to try thin wire for the claws topped with greenstuff - not sure whether it will work however. There is plasticard, however I am not convinced in it's use for this - Dobbsy did a good job however on his which is making me rethink it's use. Failing the above, I will start looking in the bits box for stuff to cut up and use for claws. Hope these ideas help Cheers... |
|
| Author: | Lextar [ Wed Sep 08, 2010 10:09 pm ] |
| Post subject: | Re: Terminator Lightning Claws |
thanks for the info, I was trying to decide whether to use plastic card too. Still a bit undecided yet. This is for the normal none chaso Terminator I am using. |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|