Autocannon turret!

_________________
Dave

Blog

NetEA Tournament Pack Website

Squats 2019-10-17

I would keep the chassis one piece, and yes, extend the track guards. I would do a seperate turret, for the reasons mentioned. Perhaps a two peice hull with a raised front and turret socket, and a choice of APC or fuel barrel plug ins for the rear Might work, though it would require reworking the utility chassis.

Designing an Axoatl Recon Vehicle as an Urn/Arma plug-in might be nice.

_________________
SG

Ghost's Paint Blog, where everything goes that isn't something else.

Will this work? Turret is separate piece.

Nice But it needs only three firing ports each side. Not four

_________________
We are returned!
http://www.epic-wargaming.de/

Looks good. My only criticism is that the troop compartment looks too tall. That and a double door like that is a lot easier to bar than a dropping ramp.

_________________
Dave

Blog

NetEA Tournament Pack Website

Squats 2019-10-17

The top I like.

You probably remember my opinion of the sides. :-)

_________________
Currently doing a plastic scenery kickstarter

No, it's the other manufacturer that has it wrong. The proper count is four. Four! (Shouts in hammy, over-acting voice).

See: http://tvtropes.org/pmwiki/pmwiki.php/Main/LargeHam

Edit - Yes, I would like it to be 4 as a point of distinction.

Er, actually, I don't. Too thick? Armor wads too waddy?

Perhabs you should have a look at Grandma Wendy's APC or Dog our of Hell for the side panels?

_________________
We are returned!
http://www.epic-wargaming.de/

I didn't like the big side panel things it has going on, I prefer the upitty-downitty side detail style.

_________________
Currently doing a plastic scenery kickstarter

Sweet! How many components did it end up being, and where do I sign up?

_________________
SG

Ghost's Paint Blog, where everything goes that isn't something else.

I like it. Although I tend to agree that a slightly lower overall profile might be nice.

_________________
Sofa General

Nobody expects the Inquisition!!!
http://theepiclounge.wordpress.com/

Yes lower will be nice
anyway again great work Otter

2 parts.

OK, I'll spend a few hours lowering it by .4mm. Then it should be even lower than SG's.

i dont think it should be lowered. personally, i think that a lot of secondary producer tanks are too low to the ground (more realistic, perhaps, but i like the chunky nature of a GW design.

that being said, the hatch in front of the turret looks wrong to me. i'd think removing that cutaway, and biggening the turret a bit, and put me down for say, 30 ^_^

_________________
~Every Tool Is A Weapon, If You Hold It Right~