Tactical Command
http://www.tacticalwargames.net/taccmd/

hornet
http://www.tacticalwargames.net/taccmd/viewtopic.php?f=24&t=22115
Page 1 of 3

Author:  asdepicas [ Fri Dec 23, 2011 4:09 pm ]
Post subject:  hornet

im preparing my saim-han army, got everything i need except for this awesome vehicle called hornet... is there any proxy that suits well? where can i see any picture of a hornet so i can make my own proxy?

Author:  SpeakerToMachines [ Fri Dec 23, 2011 4:26 pm ]
Post subject:  Re: hornet

Image

Author:  Spectrar Ghost [ Fri Dec 23, 2011 5:00 pm ]
Post subject:  Re: hornet

There are a couple DRM Andrayada (edit-Kraytonian? Can't remember) vehicles that might proxy well, or make good starts to conversions.

Author:  Evil and Chaos [ Fri Dec 23, 2011 5:02 pm ]
Post subject:  Re: hornet

That reminds me; I'm going to start an Eldar army.

Author:  Spectrar Ghost [ Sat Dec 24, 2011 1:58 pm ]
Post subject:  Re: hornet

Evil and Chaos wrote:
That reminds me; I'm going to start an Eldar army.


It's like Christmas! Oh, wait.

Author:  illuvitar [ Mon Dec 26, 2011 4:31 am ]
Post subject:  Re: hornet

Quote:
It's like Christmas! Oh, wait.

LOL

Author:  asdepicas [ Mon Dec 26, 2011 10:21 am ]
Post subject:  Re: hornet

seems quite similar to a night spinner with different turret... mmmm... i think i can transform a couple of nightspinners into this...

Author:  Evil and Chaos [ Mon Dec 26, 2011 10:34 am ]
Post subject:  Re: hornet

It's smaller, too.

Author:  Spectrar Ghost [ Mon Dec 26, 2011 10:38 am ]
Post subject:  Re: hornet

Might work. Take a look at the other images on the FW page first though, because the side view is somewhat deceptive. It's very tall in relation to it's width, which is not apparent in the three-quarters view. You can just see that it has a different engine configuration than a standard Falcon in the above image; it's set up like an F-16 - a single engine with a large ventral intake. I'm not saying it won't work, but I'm not convinced yet.

Author:  Spectrar Ghost [ Mon Dec 26, 2011 10:41 am ]
Post subject:  Re: hornet

Do you know how much smaller, E&C? Scaling against the 60mm base, I think it's not more than an inch or so shorter than a Falcon, and maybe two inches thinner at most. I think the main thing is it is much more gracile; it's apparent mass is very much smaller than the Falcon.

Author:  asdepicas [ Mon Dec 26, 2011 11:59 am ]
Post subject:  Re: hornet

been looking at the photos and seems to be the size of a vyper rather than a falcon... maybe adding a big turret to a vyper and modeling the wings a bit...

Author:  semajnollissor [ Wed Dec 28, 2011 7:53 am ]
Post subject:  Re: hornet

here's a pic for size comparison.

I included the mark II extension to the falcon, since without it the hornet would be just as long as the falcon.

Also, please excuse the quality, the shot was taken in low light with a cell phone camera.

Attachments:
comparison.jpg
comparison.jpg [ 145.67 KiB | Viewed 6543 times ]

Author:  ceimeifukan [ Fri Dec 30, 2011 3:35 pm ]
Post subject:  Re: hornet

I once played about with the idea of trimming down a scorpion turret and adding some gun pods.

Trouble is scorpion turrets don't come cheap, unless you can find a way of replicating them somehow............

I cut and paste a few images together in paint to get a feel for it if you're interested.

Image
Image

It's defintiely the right size but the profile is a bit off.

Author:  Parintachin [ Sun Jan 01, 2012 11:38 am ]
Post subject:  Re: hornet

Yup; unless we can get something Jamesy, the scorp turrets are the best bet yet.

Page 1 of 3 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/