Tactical Command
http://www.tacticalwargames.net/taccmd/

3d Printing infantry at 25 microns, 0.25 to 0.40 mm nozzle?
http://www.tacticalwargames.net/taccmd/viewtopic.php?f=126&t=31721		 Page 1 of 1
Author:  rubberlizard [ Wed Oct 12, 2016 11:18 pm ]
Post subject:  3d Printing infantry at 25 microns, 0.25 to 0.40 mm nozzle?
Any one tried printing 6mm infantry at this resolution on a filament printer? How did it end up?

I know resin printing is the way to go on printing this small, but havent seen the results on a high resolution, and is curious.
Author:  Lead-Space [ Sun Nov 27, 2016 6:25 pm ]
Post subject:  Re: 3d Printing infantry at 25 microns, 0.25 to 0.40 mm nozz
I have 0,2mm nozzle. No chance to print 6mm minis.
Author:  rubberlizard [ Mon Nov 28, 2016 6:06 pm ]
Post subject:  Re: 3d Printing infantry at 25 microns, 0.25 to 0.40 mm nozz
Lead-Space wrote:
I have 0,2mm nozzle. No chance to print 6mm minis.


Thanks.havent found alot about the resolution
Author:  Shoel [ Mon Nov 28, 2016 6:18 pm ]
Post subject:  Re: 3d Printing infantry at 25 microns, 0.25 to 0.40 mm nozz
I usually print tanks at 0,1mm layer height. It works decently for vehicles but infantry would not end well.


Skickat från min iPhone med Tapatalk
Author:  Lead-Space [ Tue Nov 29, 2016 8:50 am ]
Post subject:  Re: 3d Printing infantry at 25 microns, 0.25 to 0.40 mm nozz
example of my prints with 0.2mm nozzle

Image
Author:  rubberlizard [ Tue Nov 29, 2016 5:09 pm ]
Post subject:  Re: 3d Printing infantry at 25 microns, 0.25 to 0.40 mm nozz
Thanks for the look.

Howmuch sanding do you do on vehicles?
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/