Tactical Command
http://www.tacticalwargames.net/taccmd/

Modeling bits for 3d printing
http://www.tacticalwargames.net/taccmd/viewtopic.php?f=126&t=26022
Page 32 of 32

Author:  malika2 [ Tue Aug 18, 2020 3:29 pm ]
Post subject:  Re: Modeling bits for 3d printing

Image
Image

Author:  jimmyzimms [ Mon Aug 24, 2020 4:17 pm ]
Post subject:  Re: Modeling bits for 3d printing

Cool macuahuitl

Author:  malika2 [ Tue Aug 25, 2020 9:36 am ]
Post subject:  Re: Modeling bits for 3d printing

Grimdark meso American weaponry FTW!

Author:  malika2 [ Fri Aug 28, 2020 7:57 pm ]
Post subject:  Re: Modeling bits for 3d printing

Image

Author:  malika2 [ Mon Sep 07, 2020 11:34 am ]
Post subject:  Re: Modeling bits for 3d printing

Image

Author:  jimmyzimms [ Mon Sep 14, 2020 1:32 pm ]
Post subject:  Re: Modeling bits for 3d printing

I want to combine these buildings into one

Author:  malika2 [ Tue Sep 15, 2020 9:07 am ]
Post subject:  Re: Modeling bits for 3d printing

You could stack the ones on the left on top of the building on the right.

Author:  jimmyzimms [ Tue Sep 15, 2020 11:43 am ]
Post subject:  Re: Modeling bits for 3d printing

I should sketch up my layout out of primitives. Dimensions of the parts? Your building parts are really always awesome

Author:  malika2 [ Tue Sep 15, 2020 3:18 pm ]
Post subject:  Re: Modeling bits for 3d printing

Dimensions from left to right:
1) 35mm wide, 46.5mm deep, 94mm tall
2) 36.5mm wide, 59.75mm deep, 73mm tall
3) 58.5mm wide, 58.25mm deep, 66mm tall
4) 95.5mm wide, 95.5mm deep, 45mm tall

Author:  malika2 [ Wed Oct 28, 2020 10:39 am ]
Post subject:  Re: Modeling bits for 3d printing

A quick experiment, been very intrigued by the notion of MicroHulk, a pocket version of Space Hulk, so I started out trying to make some modular 75mm x 75mm tiles...

Image

Page 32 of 32 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/