Tactical Command
http://www.tacticalwargames.net/taccmd/

So I designed a 3D model and want it printed out, what now?
http://www.tacticalwargames.net/taccmd/viewtopic.php?f=126&t=24647		 Page 1 of 1
Author:  Corran_dk [ Sun Feb 10, 2013 12:00 am ]
Post subject:  So I designed a 3D model and want it printed out, what now?
Created this question in the wrong tread first, so now in the correct place.

So I designed a 3D model for Epic and want it printed out and eventualy cast alot of them, but I have some questions regarding the process.

1. What company do you use?
2. What material? (The model got small details (don't all Epic models?) down to 0,8mm)
3. After that what do I do, if I want to have it cast in metal?
4. Do I need to get it cast in Bronze and is anyone actually doing this in EU?

:sos
Author:  Todderman [ Sun Feb 10, 2013 10:22 pm ]
Post subject:  Re: So I designed a 3D model and want it printed out, what n
1. Shapeways
2. Frosted ultra detail
3. I use the bronze master route. E&C uses something different, so he can advise if he wishes.
4. www.ninjamagic.com, US, but should be able to ship internationally. For Exodus Wars masters I've been a conduit for reshipping.
Author:  Corran_dk [ Mon Feb 11, 2013 9:02 am ]
Post subject:  Re: So I designed a 3D model and want it printed out, what n
Todderman wrote:
1. Shapeways
2. Frosted ultra detail
3. I use the bronze master route. E&C uses something different, so he can advise if he wishes.
4. http://www.ninjamagic.com, US, but should be able to ship internationally. For Exodus Wars masters I've been a conduit for reshipping.


Thank you very much, exactly the answers I was looking for ;D
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/