Lissen up, ya gitz! 'Eres wotz new!
Two hutz into the second batch. I've done a 'Block 2' Guard Barracks, as well. Neither of these have doors or wondow's added yet however. I have a Mek Garage underway, as well.
A detail shot of the 2 story hut, showing the .040"x.080" strip I used to cover a mismeasurement. Not much different from the first batch, except instead of Grandt Line bolts, I used the IA: Masterclass water filter method.
A couple of closeups of the Mek's Garage. Several things to note here. The garage has the same dimensions as the larger hutz in the first batch (83mm x 53mm overall). It is 1 story in the rear, and two stories in the front (13mm and 23mm respectively). As I am planning on painting it to match the metal brace in the first batch, I've decided to distress the edges. I did this by randomly draging a triangular needle file across the edges. I tried scribing panel lines on the roof, and it sucked. So it was covered with a piece of tile card I had hanging around. I added a few patches in various places, again distressing the edges. This was given an all-over water filter rivet treatment, being metal construction.
I'm not satisfied with the gaps in the framing around the rolling doors, probably going to add a couple short strips to look like they are held together that way.
Do I need more patches? More rivets? Do you like the effect of the distressing?
Eventually the 1 story hut will probably be the 'offis' to the garage, at the front right of a fenced compound, while the garage sits at the rear left. I've got some ideas for adding scrap piles and buggies to the lot, but that, of course will have to wait until I get the bases cut out...
Sub-Champ, Cadian Shock Troops
, Mirali SkyraidersMankind Divided
, a Dropzone Commander Blog.Ghost's Paint Blog
, where everything goes that isn't something else.