So I finished my first print with the Anycubic, and im more than a little excited.
heres how the Mega Nob character turned out after a bit of clean up
there is actually alot of little things wrong with him and a major problem with part of his arm but all of these things were because of my inexperience with resin 3d printing and im pretty sure I can fix so im not overly concerned about them
Specifically I had too much support in certain areas, like his head, which distorted the detail and too few on at least his gun arm which resulted in a flat spot.
The other model I printed (both in the same batch) was the Big Mega Mad Mek B triple M turned out pretty good as well but his tech arm klaws were too thin and the upper chainblade receiver wasn't probably supported leading to breaks and distortion, as well as in his face.
Here they are on either side of my Warboss whos paint job is not finished.
There is two sizes of warboss in this photo, one to indicate a large warboss and the other to indicate a very large example of a warlord, akin to Thraka.
Both of the new models have a lyaer of primer and some wash, there is also some vanguard not eldar in there for size reference.
Finally heres a better shot of the Warboss
Alright those pics of the printed models werent very good so I just shot two more real quick to show detail better.
Im learning to handle 6mm proportions better now too. Gettin the hang of it I think
I likely wont be keeping these two guys as I vew them as prototypes, im likely going to give them away. If youre interested let me know