hello,
i was wondering if there was any one here that could help me with some 3d printing stuff? i have aces to a formlab1 SLA printer at my local library and have been meaning to do something along the lines of 40k tyranids for epic. i have most of the test model ready but i dont know how it will turn out and would like some input and C&C before printing.
the whole thing will be about 3cm or so, should i be worried about detail too much and exaggerate everything? im not too worried about the loss of some detail but if its a good idea to do it now. how should i go about deciding this as i think a typical learning curve for this would be to test a piece and go back to the drawing board.
this is a test piece as i want to do other things and just learning to sculpt and print. ill separate the limbs for printing and assailable them later
3